The maximum operating temperature is 45☌. To prevent the system from overheating, do not operate it in an area thatĮxceeds the maximum recommended ambient temperature of: <113☏ (45☌). When installing or replacing the unit, the ground connection must always be madeįirst and disconnected last. Ultimate disposal of this product should be handled according to all national Only trained and qualified personnel should be allowed to install, replace, or Uncertain that suitable grounding is available. The appropriate electrical inspection authority or an electrician if you are The equipment in the absence of a suitably installed ground conductor. Never defeat the ground conductor or operate The plug-socket combination must be accessible at all times, because it servesĪs the main disconnecting device. A restrictedĪccess area can be accessed only through the use of a special tool, lock and This unit is intended for installation in restricted access areas. Stabilizers before mounting or servicing the unit in the rack.
Cisco 2950 switch auto mdx install#
If the rack is provided with stabilizing devices, install the When mounting this unit in a partially filled rack, load the rackįrom the bottom to the top with the heaviest component at the bottom This unit should be mounted at the bottom of the rack if it is the The following guidelines are provided to ensure your safety: This unit in a rack, you must take special precautions to ensure that the system To prevent bodily injury when mounting or servicing Read the installation instructions before connecting the system to the power Statementĭo not work on the system or connect or disconnect cables during periods of
Result in a hazardous situation to people and damage to the system. Read the wall-mounting instructions carefully before beginning installation.įailure to use the correct hardware or to follow the correct procedures could If the chassis falls, it canĬause severe bodily injury and equipment damage. Metal objects will heat up whenĬonnected to power and ground and can cause serious burns or weld the metalĭo not stack the chassis on any other equipment. (including rings, necklaces, and watches). Read this section before you start the installationīefore working on equipment that is connected to power lines, remove jewelry This section includes the warning statements
For initial switch setup, assigning the switch IP address, and powering on information, see the switch getting started guide
0 kommentar(er)
